Melo Machine & Manufacturing, Inc.

Melo Machine & Manufacturing has operated in Patterson since 1988, when Jim Melo bought the town’s first machine shop. It repairs agricultural equipment with welding and machine work, does custom design and fabrication, and runs pump trucks for domestic and irrigation pump service.

Capabilities

• Agricultural equipment repair
• Machine work and welding
• Custom design and fabrication
• Domestic and irrigation pump installation and repair

Industries served

Agriculture.

Request a quote

To request a quote from this shop, use the Request a Quote form. Tell us the part, material, quantity and deadline, and we will pass your request to the shop.

Farm Equipment Repair and Pump Work in Patterson: Melo Machine & Manufacturing

Agriculture runs on a schedule that does not wait for parts. A harvester that breaks in season, an irrigation pump that stops in a dry week or a trailer with a cracked axle housing can cost a grower far more than the repair itself. Farmers and contractors around Patterson often look for a local shop that can both machine and weld. Melo Machine & Manufacturing is listed here for precision machining, welding, fabrication, engineering and design, repair, agricultural repair, pump repair and irrigation. This page explains how this kind of work is usually approached.

Why agricultural repair is its own skill

Farm equipment is heavy, dirty and often old. Manufacturers change designs or stop supporting models, so parts can be hard to find. A repair shop has to think like a detective. It looks at what failed, why it failed and whether a replacement should match the original or be made stronger.

Machining and welding side by side

A bent shaft might be straightened or replaced. A worn bore might be built up with weld and re-machined. A cracked frame might be welded and reinforced. These repairs depend on knowing both processes. When you ask for a quote, include photographs of the damage and the full part if you can.

Custom design and fabrication

Sometimes the answer is something new. A grower may need a bracket, a hitch, a guard or a rack built to a specific need. Custom fabrication starts with a conversation about what the item must do, followed by a sketch, a measurement check and a build. A simple drawing with dimensions is enough to begin.

Pump service

Irrigation and domestic pumps move water through wells, canals and pipes. Common problems include worn shafts, damaged impellers, failed seals and corroded housings. Machine work can restore bearing fits and shaft sizes. Installation and repair of pumps often involves trucks and lifting equipment because the pumps are heavy and deep in the ground.

Preparing for a pump or equipment repair

• Make, model and size of the equipment
• Photographs of the damaged area
• What the machine was doing when it failed
• Part numbers from any tags or plates
• The date by which the equipment must work again

Seasonal planning

Many farm repairs happen under pressure, but some can be planned. Off season is a good time to inspect wear parts and order replacements. Buyers who bring worn parts in before they fail often save money and avoid the stress of a breakdown during harvest.

Quality of the repair

A good repair lasts as long as the part it replaces, or longer. Ask what material will be used and whether the repair addresses the cause of failure. If the same part keeps breaking, the cause may be a design problem or an alignment problem rather than a bad part.

Staying local

Buyers in Patterson and the surrounding Valley benefit from shops close enough to see the equipment. A site visit can answer questions that photographs cannot.

If you need a machining or repair job, send the details through the Request a Quote form and we will send your details on to the shop.

Is this your shop? Claim or remove this listing.